Nice Pro-H - Operator Modes of Operation - Part 2; Mode T Details and Safety Features; Mode TS: Timer to Close Secure; Logic Board Replacement Warning


• Timer to close Closes the door from mid-stop or full open. Momentary activation of stop button will de-activate the
timer. hen door is closing, momentary activation of safety devices will reverse the door to mid-stop if enabled or full
open and de-activates the timer. Timer resumes its normal operation upon momentary activation of open push button or
once the close cycle is completed. If mid-stop is enabled and Timer from mid-stop only dip-switch is N, timer is
enabled only from mid-stop and disabled from full open. If mid-stop is enabled and Timer from mid-stop only dip-
switch is , timer is enabled from full open and mid-stop.
TS Momentary on open and close, timer to close secure, ST TTN ISAES TIME
• pen utton Momentary activation opens the door. hen door is closing, momentary activation reverses the door.
Momentary contact from mid-stop opens the door to full open position. Momentary contact at full-open refreshes the
timer if enabled at full open. Momentary contact at full open position re-activates the timer if timer has been disabled
previously by stop button. Constant activation when door is opening, bypass mid-stop if enabled.
• Close button Momentary on close.
• Stop button If door is opening or closing, momentary activation stops the door.
Momentary activation while timer is counting at mid-stop or full open de-activates the timer.
• Single button device, single channel transmitter and -channel ,, radio transmitter
SEENTIA NCTIN penStopCloseeve
rse.
CMMECIA NCTIN peneverseefresh timer.
• -button CS radio transmitter Same as open, close, stop buttons.
• Safety evices hen door is closing, momentary activation reverses the door.
Momentary activation refreshes the timer to close.
• Timer to close Closes the door from mid-stop or full open. Momentary activation of stop button will de-activate the
timer. Timer resumes its normal operation upon momentary activation of open push button or once the close cycle is
completed. If mid-stop is enabled and Timer from mid-stop only dip-switch is N, timer is enabled only from mid-
stop and disabled from full open. If mid-stop is enabled and Timer from mid-stop only dip-switch is , timer is
enabled from full open and mid-stop.
arning hen replacing the logic board in a single-phase operator,
Make sure that umper  is installed properly before operating the door.
ailure to do this will damage the logic board.
AMMIN INSTCTINS
NTE A AM NCTINS CAN E INITIATE Y TNIN TE
SEECT STIC T TE ESIE SETTIN AT ANY INT IN
EATIN ECET  TE MI ST and N TIME ME,AMMIN
MST STAT M TE  CSE SITIN.
N-TIME SET
un-timer is the maximum amount of time the motor will run upon receiving an
open or close command. The factory default value for run-timer is  seconds.
Note imits must be set prior to setting run timer
Modify the run-timer from factory default
. Close the door to full close position.
. Set the selector dial to un-timer position. The elay n Close Timer
E should blink.
. ress open button. ait until door reaches full open position. The run timer value is set
to the time taken for the door to travel from full close position to full open position plus 
seconds.
. Set the selector dial to the desired mode of operation.
Modify the run-timer to factory default
. Close the door to full close position.
. Set the selector dial to un-timer position.
. ress stop button. The run-timer is modified to the factory default value. Then set the selector dial to the
desired mode of operation.