Why does my Nice Door Opening System manoeuvre start but then reverse?
If your Nice Door Opening System's manoeuvre starts but immediately reverses, it could be due to several reasons. First, the selected force might be too low for the automation type. Second, check for any obstacles and increase the force if needed. Finally, verify whether a safety device connected to the Stop input has been triggered.
What to do if Nice Door Opening System radio transmitter LED is on but doesn't control?
If the radio transmitter for your Nice Door Opening System isn't controlling the automation, but the LED on the transmitter is lit, the transmitter may not be correctly memorized in the radio receiver. Check the radio receiver settings to ensure the transmitter has been properly registered.
How to fix Nice SPIDER Door Opening System when radio transmitter doesn't work and the LED is off?
If the radio transmitter for your Nice Door Opening System doesn't control the automation and the LED on the transmitter isn't lighting up, the batteries in the transmitter might be dead. Replace them with new ones to see if that resolves the issue.
What to do if Nice Door Opening System manoeuvre completes but the warning light is off?
If the manoeuvre completes correctly, but the warning light on your Nice Door Opening System doesn't work, first, check for voltage on the warning light’s FLASH terminal during the manoeuvre. If there's voltage, replace the lamp with one having the same characteristics. If there's no voltage, there may have been an overload on the FLASH output, so check that the cable has not short-circuited.
General| Brand | Nice |
|---|---|
| Model | SPIDER Series |
| Category | Door Opening System |
| Language | English |
To Next Page
