Nice SPIDER Series

ENGLISH – 37
9.4 RADIO DIAGNOSTICS
Table 29
SIGNAL OF LED R ON THE CONTROL UNIT
Long ashes > GREEN at start-up
Current encoding system: “O-Code” 2
No remote control memorised 5
Long ashes > GREEN during operation
Indicates that the code received is not stored in the memory 1
Saving of the code in memory 3
Memory deleted 5
During programming, indicates that the code is not authorised for memorisation 6
During programming, indicates that the memory is full 8
Short ashes > GREEN
“Certicate” not valid for memorisation 1
During programming, it indicates that the code cannot be memorised because it transmits the “certicate” 2
Output in “Mode 2” not managed on the control unit 4
During the deletion procedure, indicates that the code has been deleted 5
“Certicate” with lower priority than the admissible level 5
Code synchronisation failure 6
Long ashes > RED
Non-original code block 1
Code with lower priority than the authorised level 2
Short ashes > RED
“In vicinity” programming block 1
“Certicate” memorisation block 1
Memory block (PIN entry) 2
Long ashes > ORANGE
(At start-up, after a few green ashes). Indicates the presence of two-way transmitters 1
Short ashes > ORANGE
Indicates activation of block programming (at start-up) 2