How to fix Nice Garage Door Opener when the radio transmitter doesn't control the door and the LED on the transmitter does not light up?
If the radio transmitter isn't controlling the garage door and the LED on the transmitter remains unlit, the suggested solution is to check the transmitter batteries. If they're exhausted, replace them.
What to do if Nice Garage Door Opener doesn't start and the OK LED fails to light up?
If no manoeuvre starts and the OK LED doesn't light up, check if the gearmotor is receiving power at 230 V mains voltage. Also, verify that fuses F1 and flash F2 haven't blown. If they have, determine the cause of the fault and replace them with fuses having the same current rating and characteristics.
Why Nice Garage Door Opener radio transmitter does not control the door but the LED on the transmitter lights up?
If the radio transmitter is not controlling the door, but the LED on the transmitter lights up, verify that the transmitter has been correctly memorized in the radio receiver. Also, check if the transmitter emits the radio signal correctly by pushing a key and placing the LED on the antenna of a normal radio (tuned to 108.5 MHz FM or as close as possible); a slight crackling sound should be heard.
What to do if Nice Garage Door Opener manoeuvre starts but is immediately followed by a brief reverse run?
If the garage door opener manoeuvre starts but is immediately followed by a brief reverse run, the selected force value might be too low to move the door. Check for any obstructions. If there are none, select a higher force setting.
What to do if Nice Garage Door Opener manoeuvre does not start and the courtesy light flashes a few times?
If the garage door opener manoeuvre doesn't start and the courtesy light flashes a few times, count the number of flashes and check them against Table 22.
What to do if Nice Garage Door Opener manoeuvre doesn't start and the warning light is off?
If no manoeuvre starts and the warning light is off, check that the command is actually received. If the command reaches the Step-by-Step input, the OK LED flashes twice indicating that the command has been received.
General| Power Supply | 230 V AC, 50 Hz |
|---|---|
| Operating Temperature | -20°C to +50°C |
| Speed | Up to 0.2 m/s |
| Remote Controls Included | 2 |
| Security | Rolling code |
| Warranty | 2 years |
| Motor Type | DC |
| Drive Type | Chain |
To Next Page
