54 – ENGLISH
OPERATING MODE DESCRIPTION
Open 2
The opening sequence is executed.
WARNING = If the command persists for more than 2 seconds, the control unit executes a “partial opening 1” command.
Hold-to-run open
The opening manoeuvre is executed exclusively if the command is persistent (hold-to-run). When the control is released, the
control unit executes a STOP command.
Condominium Step-by-Step
The “close - stop - open - open” sequence is executed until the maximum opening position is reached. If another command
is sent after this one, the application executes the closing manoeuvre with the same sequence.
Condominium Step-by-
Step 2
The “close - stop - open - open” sequence is executed until the maximum opening position is reached. If another command
is sent after this one, the application executes the closing manoeuvre with the same sequence.
WARNING = If the command persists for more than 2 seconds, the control unit executes a “Stop” command
Step-by-step 2
This executes the sequence “open - stop - close - open”.
WARNING = If the command persists for more than 2 seconds, the control unit executes a “partial opening 1” command
Stop
When the control unit receives the command, it stops the manoeuvre in progress gradually and in a short time (not
instantly).
Stop and brief reversal
The control unit stops the manoeuvre in progress and causes the automation to perform a brief reversal in the opposite
direction
Stop and reversal
The control unit causes the current manoeuvre to stop and activates the full reversal in the opposite direction.
The control unit causes the current manoeuvre to stop and activates the full reversal in the opposite direction.
Temporary stop
The control unit stops the current manoeuvre so long as the command remains active. When the command is no longer
active, the control unit causes the application to perform an opening manoeuvre.
WARNING = During the execution of the opening manoeuvre, this command is ignored
Stop When the control unit receives the command, it instantly stops the manoeuvre in progress.
Stop and brief reversal
When the control unit receives the command, it instantly stops the manoeuvre in progress and causes the application to
perform a brief reversal in the opposite direction.
Stop and reversal
When the control unit receives the command, it stops the manoeuvre in progress immediately and causes the application to
perform a full reversal in the opposite direction
To Next Page
Loading...
Need help?
General
