Nice Pro-H - Programming Instructions - Part 2; Radio Receiver Basic Operation; Erasing Transmitters; Remote Control Battery Replacement


AMMIN TE N-A AI ECEIE
arning uring programming, door operator will activate. eep people and obects away from door.
. Connect power to door operator.
. ress and release the learn button once. The receivers E will turn on.
. To program a single button transmitter, press the button on the
transmitter. The receivers E will blink twice indicating a
successful programming.
. ress the button on the transmitter once more to confirm operation
of the door operator.
. To program a -channel ,, transmitter, press any of the  buttons on the transmitter. The receivers
E will blink twice indicating a successful programming. ress the same button on the transmitter to confirm
operation of the door operator. This button is now associated with that particular receiver. You can repeat the
programming process for the other two buttons to control two other receivers.
. To program a -button CS transmitter, press EN button on the transmitter. The receivers E will blink
twice indicating a successful programming. ress the EN button on the transmitter to confirm operation of
the door operator. EN, CSE and ST buttons on the transmitter can be used to open, close and stop
the operator respectively.
. Test range of transmitter. epositioning antenna may provide greater range.
. epeat transmitter-programming steps for additional transmitters.
EATIN
.
.
ress and release the button on Nice transmitter.
eceiver E will light momentarily and door will cycle.
T EASE A EANE TANSMITTES
. ress and hold down the EAN button.
. After  seconds, the E will blink for  seconds.
. elease the EAN button during the time E is blinking.
. After you released the button, the E will blink  times indicating all transmitters are erased from the
receivers memory.
Note  maimum of  transmitters can be programmed for the same receier f more than  are reuired consult
factor
EACIN EMTE CNT ATTEIES
The batteries lithium,  should produce power for up to  years. To replace the battery, open the transmitter by
removing the screws on the back of the transmitter. Match the positive and negative terminals of the battery to the
positive and negative terminals of the transmitter.
Note The receiver and transmitter comply with part  of the CC rules with SS- of industry Canada. peration
is subect to the following two conditions  this device may not cause harmful interference, and  this device must
accept any interference received, including interference that may cause undesired operation.
Note If an external radio-receiver Nice or other is used instead of the built-in radio receiver, it is highly
recommended to disconnect the co-axial cable from the logic board.
Note hen using any external receiver, the Nice on-board receiver should not be used.