Nice Pro-H - Dipswitch and Status LED Configuration; Dipswitch Settings; Status LED Indicators


ISITC SET
ip-switch N 
NTE
SECM
Single button and
radio in SE mode
Single button and
radio in CM mode
Mid-stop
timer
Timer is enabled
from mid-stop only
Timer is enabled
from both mid-stop
and full open
T or TS mode must be
selected to enable a timer
for mid-stop
elay on
reverse
elay on reverse
is . seconds
elay on reverse
is . seconds
Nice recommends . sec
delay on reverse for all
applications
Motor
direction
everse motor
direction
Standard motor
direction
See Note  below
NTE If motor direction is reversed, the open and close limit switches are automatically reversed. owever, the
advanced close limit switch needs to be manually changed. To do this, disconnect the  wires from the advanced
closed limit switch and re-connect to the auxiliary limit switch provided.
STATS E
E Status Cause
ault N -rimary safety devices not connected to  
 or not functioning properly
-Safety devices are activated
-k hm resistor between S  S removed
or faulty
ault linking
- Interlock is activated.
- Interlock umper is not connected.
un-out timer N - un-out timer has elapsed
elay on close timer
linking
- elay on close timer is counting.
- Selector dial is set to un-timer.
Timer to close linking
Timer to close is counting.
Safetyhoto N
-rimary safety devices not connected to  
 or not functioning properly
-Safety devices are activated
-k hm resistor between S  S removed
or faulty
Mid. Stop N
oor is at Mid-stop position.
Close imit N
Close limit switch is activated.
pen imit N
pen limit switch is activated.
Stop  N

-
Stop button connected and functioning
- Stop push button is activated or the stop
circuit is open.
Close elay linking
- oor is closing.
- Close relay is activated.
pen elay linking
- oor is opening.
- pen relay is activated.
ower N  AC power to logic board is N.