AA N- T-EAM TCE M
ote he M photocell sstem has a maimum range of ft un isor protector optional
. Select a location on the wall no more than inches from the floor to install wall mounting brackets on the left
and right side of the door. oth brackets must be mounted at the same height for proper alignment.
. rill holes in the wall and attach brackets to the wall using screws provided as shown in ig. .
ig.
. lug sensors into flexible adapters as shown in ig. . lease note that the brackets are not identical. The
receiver x must be installed into the receiver adapter and the transmitter Tx must be installed into the transmitter
adapter ig. .
ig. ig.
. air the two black and the two black with white tracer wires together from transmitter and receiver. Connect these
paired wires to the and terminals on the logic board or interface module if applicable as shown in ig
. se minimum gauge wires and secure the wires to wall or ceiling.
. Turn the power on to the operator. Align transmitter and receiver by adusting angle and height of the fixture ig. A
and .
ig. A Angle Adustment ig.
eight adustment
oosen wing nut first
. tilie Es on photocells for alignment and trouble shooting. Make sure to tighten screws and wing nuts
after photocells are aligned.
• ed E N, reen E N Normal operation
• ed E , reen E No power. erify wiring
• ed E linking twice, reen E N ad Alignment, or bstructed eam, or x defective
• ed E linking twice, reen E Check power and wiring to x, or x defective
• ed E linking three times, reen E N x receiving sunlight or interference. Install viso
r
or interchange position of transmitter and receiver to reduce sunlight affecting receiver.
To test the photo system pen the door to full open position. Close the door. hen door is closing, obstruct the
beam. The door should stop and reverse.
To Next Page
Loading...
