English – 3
1
PRODUCT DESCRIPTION AND INTENDED USE
ROBO is an electromechanical gearmotor intended for automating residential sliding gates: it is equipped with an electronic control unit with
integral 433.92 MHz radio receiver with O-CODE coding.
CAUTION! – All uses other than the intended use described and use in environmental conditions other than those described in
this manual should be considered improper and forbidden!
The essential characteristics of the ROBO gearmotor are described in Table 1.
Table 1 – Essential characteristics
ROBO600
Gate limit (m) 8
Weight limit (kg) 600
Power (V~) 230
Nominal power (W) 300
Peak thrust (Nm) 18
corresponding to force (N) 600
Rated torque (Nm) 9
corresponding to force (N) 300
Work cycle (cycles / hour) 20
Notes: 1 kg = 9.81N (example: 600N = 61 kg)
2
APPLICATION LIMITS
The effective suitability of ROBO to automate a particular sliding gate depends on the friction as well as other correlated factors, such as ice, that
could interfere with the movement of the gate.
Measure the force required to move the gate through its entire stroke and check that this does not exceed 25% of the ‘maximum force’ (chapter
13 - technical specications): this leaves a suitable margin for unfavourable climatic conditions which can increase friction.
Table 2 – Application limits
ROBO600
Gate width (m) max No. of cycles / hour max No. of consecutive cycles
Up to 4 40 20
4 ÷ 6 25 13
6 ÷ 8 20 10
8 ÷ 10 - -
10 ÷ 12 - -
Caution! Any other use or use with dimensions greater than specied is non-conforming. Nice declines all liability for damage
and injury resulting for non-conforming use.
To Next Page
Loading...