Nice ROX1000/V1 Instructions And Warnings For Installation And Use

English – 17
7.3.2 - “Remote” memorisation
You can memorise a new transmitter without having to operate the receiver key (10-20 m from the receiver).
You must have a previously memorised transmitter (old). The new transmitter will be memorised with the same characteristics as the old one.
Important! Remote memorisation may be done on all receivers within the range of the transmitter; therefore, only the one in-
volved in the operation should be kept switched on.
Standard procedure Alternative procedure
During the procedure, if the old transmitter was memorised in: During the procedure, if the old transmitter was memorised in:
- Mode 1 ¨ press any key
- Mode 2 ¨ press the key you wish to memorise
- Mode 1 ¨ press any key
- Mode 2 ¨ press the key you wish to memorise
01. With the motor stopped, stand close to the control unit
02.
NEW
transmitter
*
x 5s
03.
OLD
previously
memorised
transmitter
x 1s x 1s x 1s
04.
NEW
transmitter
*
x 1s
01. With the motor stopped, stand close to the control unit
02.
NEW
transmitter
*
x 3s
03.
OLD
previously
memorised
transmitter
**
x 3s
04.
NEW
transmitter
*
x 3s
05.
OLD
previously
memorised
transmitter
**
x 3s
RADIO LED
not visible
at a distance
If the procedure terminated successfully the new transmitter is
memorised
* same key as NEW transmitter
If the procedure terminated successfully the new transmitter is
memorised
* same key as NEW transmitter
** same key as OLD transmitter
The RADIO LED can also perform the following:
1 rapid ash if the transmitter is already stored, 6 ashes if the transmitter's radio coding is not compatible with that of the control panel receiver
or 8 ashes if the memory is full.
7.3.3 - Deleting radio transmitters
This procedure can be carried out ONLY if the radio memory is unlocked.
Table 10
Transmitter deleting procedure
= RADIO key = RADIO led
1
Hold down the RADIO key
on the control unit until step 02
2
Wait for the radio led R to come on, then wait for it to go off and
nally wait for 3 ashes
3
Release the key during the 3rd ashing
If the memorisation has been successful, the radio led R on the
control unit ashes 5 times

Nice ROX1000/V1 Specifications

General

Brand	Nice
Model	ROX1000/V1
Category	Gate Opener
Language	English