Nice RUN1500 - Conformity

28 – ENGLISH
CONFORMITY
13
13 CONFORMITY
EU Declaration of Conformity
and declaration of incorporation of “partly completed machinery”
Note - The contents of this declaration correspond to declarations in the ofcial document deposited at the registered ofces of Nice S.p.a. and in particular to the last revision available before
printing this manual. The text herein has been re-edited for ed
itorial purposes. A copy of the original declaration can be requested from Nice S.p.a. (TV) I.
Number:
238/RUN Rev: 13 Language: EN
Manufacturer’s Name:
Nice s.p.a.
Address:
Via Pezza Alta 13, Z.I. Rustignè, 31046 Oderzo (TV) Italy
Authorized Person to constitute
technical documentation:
Nice s.p.a.
Type of product:
Electromechanical gear motor with incorporated control unit
Model/Type:
RUN1500, RUN1500P, RUN1500/V1
Accessories:
Refer to the catalog
The
undersignedRobertoGriffa,intheroleofChiefExecutiveOfcer,declaresunderhissoleresponsibilitythattheproductdescribedabovecomplieswiththe
provisions
laid down in the following directives:
•
Directive 2014/30/EU (EMC), according to the following harmonized standards: EN 61000-6-2:2005, EN 61000-6-3:2007+A1:2011
The product also complies with the following directives according to the requirements envisaged for “partly completed machiner
y” (Annex II, part 1, section B):
•Directive
2006/42/ECoftheEUROPEANPARLIAMENTANDCOUNCILof17May2006relatedtomachineryandamendingtheDirective95/16/EC(recast).
It is hereby stated that the relevant technical documentation has been compiled in accordance with annex VII B of Directive 2006/42/EC and that the following essential
requirements
havebeenfullled:1.1.1-1.1.2-1.1.3-1.2.1-1.2.6-1.5.1-1.5.2-1.5.5-1.5.6-1.5.7-1.5.8-1.5.10-1.5.11
The manufacturer undertakes to transmit to the national authorities, in response to a reasoned request, the relevant information on the “ partly completed machinery “, while
maintaining full rights to the related intellectual property.
Should
the“partlycompletedmachinery”beputintoserviceinaEuropeancountrywithanofciallanguageotherthanthatusedinthisdeclaration,theimporteris
obliged
to arrange for the relative translation to accompany this declaration.
The
“partlycompletedmachinery”mustnotbeuseduntilthenalmachineinwhichitisincorporatedisinturndeclaredascompliant,ifapplicable,withtheprovisions
of
directive 2006/42/EC.
The product also complies with the following standards:
EN 60335-1:2012+A11:2014, EN 62233:2008, EN 60335-2-103:2015
Oderzo,
16/05/2018
Ing. Roberto Griffa
(ChiefExecutive
Ofcer)