Nice TOO Series User Manual

To ensure that the level of safety of the installation is maintained and
that the system remains reliable and operational, it must be serviced
regularly in observance of the safety regulations given in this manual and
established legislation.
The gearmotor must be serviced no later than 6 months after commis-
sioning.
01. Disconnect all power supplies
02. Check for any deterioration in automation system components, pay-
ingspecialattentiontoerosionoroxidationofitsstructuralparts.
Replace any parts which are below the required standard.
03. Check that all screw fasteners are fully tightened down
04. Check the wear of all moving parts and replace any worn compo-
nents
05. Connect the power supplies up again, and run all the tests and
checks described in Chapter 5.
Fortheotherequipmentinthesystem,refertoitsusermanuals.
The following optional accessories are available:
ACCESSORIES for the 230V version
PLA10
PLA11
ACCESSORIES for the 24V version
PLA10
PLA11
PS124
Refer to the user manuals of the various individual products.
This product is an integral part of the automation and must be
scrapped with it.
At the end of the product's service life, the product must be scrapped
byqualiedstaff.
This product is made up of a variety of materials, some of which can
be recycled while others must be disposed of. Check that regulatory
recycling and scrapping facilities are available locally.
Caution! – some parts of the product may contain polluting or hazard-
ous substances which, if disposed of into the environment, constitute
serious environmental and health risks.
As indicated by the symbol, the product may not be dis-
posed of as domestic waste.
Sort the materials for disposal, according to the meth-
ods envisaged by current legislation in your area, or
return the product to the retailer when purchasing a new
version.
Caution!–Locallegislationmayenvisageseriousnesintheeventof
abusive disposal of this product.
5.2 - Commissioning
Commissioning may only be done when all the gearmotor tests speci-
edinpar.5.1,andthoseoftheotherequipment,havebeenpassed:
to commission the unit, refer to the control unit manual.
IMPORTANT - It is not permissible to execute partial commis-
sioning or to enable use of the system in makeshift conditions.
7
MAINTENANCE
6
OPTIONAL ACCESSORIES
8
DISPOSAL OF THE PRODUCT
EN
3 – English

Nice TOO Series Specifications

General

Power supply (Vac/Hz)	230/50
Operating Voltage	230V
Max Gate Width	3 meters
Model	TOO Series
Control Type	External control unit (e.g., Nice control units)
Battery Backup	Optional, via compatible control unit and battery kit.