14 – English
EN
The red led, conversely, indicates that a dangerous situation or system malfunction
has been detected.
7.2 - FLW200 SIGNALS
7.2.1 - Signaling with control unit on stand-by
When the control unit is stopped (not maneuvering), and you remove the battery
from the device in question and put it back, the device will execute the following
signals:
Flashes Meaning
1 red flash The transmitter is not combined with any receiver
1 red flash,
1 red flash
The device is not combined with any interface and
the attempt to combine it was unsuccessful
1 green flash,
1 red flash
The device is not combined with any interface but
the combined interface does not respond
1 green flash,
1 green flash
The device is combined with an interface and the
combined interface does not respond properly
1 red flash,
1 red flash
At least one of the combined devices has an unchar-
ged battery; in the previous maneuvers, at least one
of the devices had communication problems
7.2.2 - Signals when the control unit is manoeuvring
During an operation, led A (fig. 4) flashes green once every second. If the battery
is low, the led changes to red.
led B (the middle one) (fig. 4) comes on once every 4 seconds when the device is
charging the battery, or, when there is a sufficient level of solar radiation.
To Next Page
Loading...
