Niceboy HIVE PODS - Resetting the Earphones; Manual Pairing Procedure

20
RESTARTING THE EARPHONES
1. Take out one headphone from the charging box. As soon as the
diode starts to ash orange and white, press the control button on
the headphone twice.
2. As soon as the diode starts to ash white, press the control button
three times. The diode will then ash orange. As soon as the diode
starts to ash white, set the headphone aside from the box.
3. Repeat the same steps with the other headphone.
4. When the diode on the left headphone starts to ash white and the
right headphone starts to ash orange, place both headphones into
the charging box.
5. After restarting, the left and right headphones will no longer be
paired together. It is necessary to connect the headphones together
once more (see the next point) before you connect them to your
device.
HOW TO MANUALLY PAIR BOTH EARPHONES TO
EACHOTHER
If the LEDs (1) are ashing orange and white on both earphones, it
means that the earphones are not connected to each other, and
it is therefore necessary to reconnect them. To do so, follow the
stepsbelow:
1. Hold the earphones close together.
2. Press the control button (2) on the left earphone twice. The LED will
start ashing white. If not, double-press once again.
3. Press the control button (2) on the right earphone twice. Automatic
pairing of both earphones will begin. LEDs will indicate the
completion of this process, the one on the right earphone will ash
orange and white, the one on the left earphone will no longer be lit
EN