NICEDAY 701ML - Step 3: Rear Stabilizer Installation; Step 4: Handlebar Tube Attachment

Take out the Screws (NO.14)*2, Nuts (NO.12)*2, Washers (NO.4)*2 from the toolkit. Install the Rear Stabilizer
(NO.16) as shown in figure below, and fix it with Open-end Wrench (B)
STEP 3
Take out the Handlebar Tube (NO.6), insert it into the hole of the Main Frame(NO. 8) as shown, lock the Knob
(NO.7) and tighten it.
STEP 4
B
B
6