3
Rev. 2 – 10
th
November2015
Safety Instructions
The following warnings, cautions and notes are provided for your safety and as a means of preventing
damage to the product or components at the connected machines. This section lists warnings, cautions and
notes, which apply generally when handling the Nicotra Gebhardt Driver, classified as General, Transport
& Storage, Commissioning, Operation and Repair.
Specific warnings, cautions and notes that apply to particular activities are listed at the beginning of the
relevant chapters and are repeated or supplemented at critical points throughout these sections.
Please read the information carefully, since it is provided for your personal safety and will also help
prolong the service life of your DDMP fan.
General
This equipment contains dangerous voltages and controls potentially dangerous rotating
mechanical parts. Non-compliance with these warnings or failure to follow the
instructions contained in this manual can result in loss of life, severe personal injury or
serious damage to property.
Only suitable qualified personnel should work on this equipment, and only after becoming
familiar with all safety notices, installation, operation and maintenance procedures
contained in this manual. The successful and safe operation of this equipment is
dependent upon its proper handling, installation, operation and maintenance.
Children and the general public must be prevented from accessing or approaching the
equipment!
Risk of electric shock! The DC–BUS capacitors remain charged after mains supply has been
switched off. It is not permissible to open the equipment until 10 minutes after the mains
supply has been removed.
This equipment may only be used for the purpose specified by the manufacturer.
Unauthorized modifications and the use of spare parts and accessories that are not sold
or recommended by the manufacturer of the equipment can cause fires, electric shocks
and injuries.
Keep these operating instructions within easy reach of the equipment and make them
available to all users. Whenever measuring or testing has to be performed on live
equipment suitable electronic tools should be used.
Before installing and commissioning, please read these safety instructions and warnings
carefully and all the warning labels attached to the equipment.
Make sure that the warning labels are kept in a legible condition and replace missing or
damaged labels.
To Next Page
Loading...
Need help?
General
