Nidec Control Techniques Digitax-SF DA22423 - Page 272


Digitax SF Instruction Manual
Operation
６
6. Operation
5. Position Control Mode
5. Position Control Mode
Homing with Digitax SF Connect
１．ParameterTab
Settinghomingparameters
2．PointTableTab
ClickServoON
（HavethemotorinaServo-ONstate）
3．ClickStarttostarthoming
・ClickPausetopausehoming
・Whenhomingiscompleted,theindicatortotheleftof
theStartbuttonwillturngreenandtheCurrentposition
cellwillshowthecurrentpositionresultingfromhoming.
Start
Stop
Required Parameters
Parameter No. Name Setting
2.0  0
3.0  3
9.0 

0
1Digitax SF Connect
642.0


0

drive
