Need help?Do you have a question about the Nidec Control Techniques Digitax-SF DA28C23 and is the answer not in the manual?
General| Model | Digitax-SF DA28C23 |
|---|---|
| Type | Servo Drive |
| Series | Digitax-SF |
| Enclosure Rating | IP20 |
| Communication Protocols | EtherCAT, CANopen, Modbus RTU |
| Control Modes | Position, Velocity, Torque |
| Protection Features | Overcurrent, Overvoltage, Undervoltage, Overtemperature |
| Operating Temperature | 0°C to 40°C |
| Humidity | 5 to 95% non-condensing |
| Power Supply Voltage | 200-240VAC ±10%, 50/60Hz |
Details motor models, parts, specifications for various power ratings (50W to 2kW), and includes encoder specifications.
Covers motor installation, drive installation, mounting orientation, and clearance requirements for proper setup.
Details system wiring patterns, recommended peripherals, EMC noise filters, AC supply contactors, and surge absorbers.
Details pin assignments, interface circuits, and signal descriptions for all CN1 connector pins.
Lists and details various parameters, including common, RS-485, drive limit switch inputs, and tuning parameters.
Explains operating modes based on Control and Command modes, configuring parameters No.2.0 and No.3.0.
Details Pulse Train Command, Internal Position Command (Point Table), Homing, and operation by User I/O.
Details parameters for tuning, including inertia condition, control gain set, mode switch, and tuning items.
Provides a list of alarms (System, EEPROM, Product code, Overspeed, Speed, Position, Overload, etc.) and their remedies.
Offers solutions for common problems like no display, no current to motor, unstable motion, positional disturbance, and vibration/noise.
To Next Page