The Computer
5-50 Manual # 42-02-1P28 A3
CAR CALLS DISABLED (252) Description: Car calls have been disabled. Typically caused by car opera-
tion in a mode or during a fault condition in which car calls are not active.
Troubleshooting:
If in error, check Home screen to see what mode of operation is displayed
and if any faults are displayed.
Troubleshoot the active mode and/or fault condition.
CAR DELAYED DOOR CLOSED (218) Description: The car has been delayed in answering a registered call while
the doors are closed. Informational. Fault-bypassed in Construction.
Troubleshooting:
Check the Car Delayed Timer setting. It might be too short.
Check for any faults that might be preventing the car from moving in a
timely manner.
CAR DELAYED F DOOR OPEN (38)
CAR DELAYED R DOOR OPEN (785)
Description: The car has been delayed in answering a registered call while
the doors are open. Informational. Fault-bypassed in Construction.
Troubleshooting:
Check the Car Delayed Timer setting. It might be too short.
Check for any faults that might be preventing the car from moving in a
timely manner.
CAR HOLD (338) Description: The car is on hold and not allowed to move. Used for the EMS
Hold function initiated when the car is on in-car EMS mode and the in-car
EMS switch is deactivated while the car is away from the EMS floor.
CAR STOP SW BYPASSED (211) The car stop switch is being bypassed. Normally due to PH1 Fire.
CAR STOP SW ON (2) Description: Car stop switch input active. If moving, the car will perform
an emergency stop. Doors will not be allowed to move. The event will end
when the switch is returned to the off position.
Troubleshooting:
If in error, troubleshoot the SAFC input and the switch.
CAR STOP SW ON RE-LEVEL (217) Description: Car stop switch activated during releveling. Car will complete
releveling. Doors remain operational. Informational event. Resets when
switch returned to Off position.
CARTOP CONSTRUCT/BYPASS (215) Description: Car Panel inspection is active and one or both of the Car/
Hoistway Door Bypass switches is in the Bypass position. Cannot be
bypassed.
System Verifies:
- ModeofOperation = OpModeInspectionBPCP
Troubleshooting:
Turn off one or both of the Car/Hoistway Door Bypass switches.
CARTOP CONSTRUCTION (53) Description: The car is on construction operation and is being operated
from the cartop inspection station. Cannot be bypassed.
System Verifies:
- Mode of Operation = Construction CT
Troubleshooting:
Exit construction operation (Please see Set Up for Construction Operation
on page 3-4).
CARTOP INSP./BYPASS (115) Description: Cartop inspection is active and one or both of the Car/Hoist-
way Door Bypass switches is in the Bypass position. Cannot be bypassed.
System Verifies:
- ModeofOperation = OpModeInspectionBPCT
Troubleshooting:
Turn off one or both of the Car/Hoistway Door Bypass switches.
Table 5.10 Touch Screen Event Listings
Event Description
To Next Page
Loading...
