To Next PageTo Next PageWhat to do if Nidek Medical LE-700 Edger displays an error message?
If your Nidek Medical Edger displays an error message and stops, it means an abnormality has been detected. Try turning the instrument off and then on again to resolve the issue.
Why Nidek Medical Edger processing won't start?
If the Nidek Medical Edger doesn't start processing when you press the button, ensure that the processing chamber cover is fully closed. Also, the instrument might be trying to process a lens that has already been processed; in this case, switch the side of the lens to be processed.
How to fix communication issues with Nidek Medical LE-700?
If communication cannot be performed with your Nidek Medical Edger, verify that the RS-232C cable or LAN cable is properly connected.
What to do if Nidek Medical Edger traced size is deviated?
If the traced or processed size, axis, bevel, or groove position of your Nidek Medical Edger suddenly deviates, perform readjustment after calibration.
Why lens shape blinks on Nidek Medical LE-700 Edger layout screen?
If a part of the displayed lens shape on the layout screen of your Nidek Medical Edger blinks after lens shape measurement, it indicates that the lens diameter is insufficient. After releasing the lens, replace it with a larger one or change the layout.
What to do if lens cup is hard to insert in Nidek Medical LE-700 Edger?
If the lens cup of your Nidek Medical Edger cannot be smoothly inserted into the lens adapter or easily detached, adjust the plunger of the cup holder.
What to do when Nidek Medical LE-700 Edger shows a maintenance message?
If a maintenance message is displayed and the Nidek Medical Edger stops, perform the remedy according to the maintenance message.
General| Beveling | Yes |
|---|---|
| Grooving | Yes |
| Polishing | Yes |
| Frequency | 50 / 60 Hz |
| Edging Material | Polycarbonate |
| Voltage | 220-240 V |
| Type | Automatic |
| Power Requirements | AC 100 to 120V / 200 to 240V |
| Lens Diameter | 30-80 mm |
| Lens Size Range | 30-80 mm |
