Nieco MPB94 - Page 26

26
Nieco Corporation - Model MPB94
Scrape each shaft of both belts on the discharge
end with the wide end of the shaft cleaning tool.
The tool is located on the clip on main side control
box.
Wipe shaft cleaning tool with a towel.
Chain Shafts
D
ischarge End
Tools
Instructions
Clean: Daily
1.
2.
Shaft Cleaning
Tool
Lift and slide the grease trough out of the broiler.
Take to sink area and spray with degreaser.
Wash with a scrub pad, rinse, and sanitize in the
3-compartment sink.
REASSEMBLY: Be sure grease trough is pushed all
the way into the broiler.
Grease Trough - P/N 16307
Side
Tools
Instructions
Clean: Daily
1.
2.
3.
3-Compartment Sink
Scrub Pad
Heat Resistant Gloves
Degreaser