80
t
5
Frame the photograph and shoot.
Note that the timer may not start or a photograph may not be
taken if the camera is unable to focus or in other situations in
which the shutter can not be released. Turning the camera off
cancels remote control mode. Remote control mode is cancelled
automatically if no operations are performed for about ten min-
utes after the mode is selected in Step 3.
From a distance of 5 m (16 ft) or less,
aim the ML-L3 at the infrared receiver
on the front of the camera (0 2) and
press the ML-L3 shutter-release but-
ton. If " is selected, the self-timer
lamp will light for about two seconds
before the shutter is released. If # is
selected, the self-timer lamp will flash
after the shutter has been released.
A
Movie Mode
The ML-L3 shutter-release button functions as the movie-record button
for advanced movie mode (0 48).
A
Using a Flash
When using the built-in flash, press the flash pop-up button to raise the
flash before shooting. Shooting will be interrupted if the flash is raised
while the delayed-remote timer is counting down.
In remote control mode, the flash starts charging while the camera is
waiting for the signal from the remote. The camera will only respond to
the shutter-release button on the remote control when the flash is
charged. If red-eye reduction (0 82) is used when # is selected, the
shutter will be released about one second after the red-eye reduction
lamp lights. If " is selected, there will be about a two second delay
after the shutter-release button on the remote control is pressed; the
red-eye reduction lamp will then light for about one second before the
shutter is released.