34
z
D Before Using the Remote Control
Before using the remote control for the first time, remove the clear plastic battery-insulator
sheet.
A Cover the Viewfinder
When taking photos without your eye to the
viewfinder, remove the DK-20 rubber eyecup
(q) and insert the supplied DK-5 eyepiece cap
as shown (w).
This prevents light entering via
the viewfinder interfering with exposure.
Hold
the camera firmly when removing the rubber
eyecup.
D Using the Built-in Flash
Before taking a photograph with the flash in P, S, A, or M modes, press the M (Y) button to
raise the flash and wait for the M indicator to be displayed in the viewfinder (0 24).
Shooting
will be interrupted if the flash is raised while a remote control mode is in effect or after the
self-timer has started.
If the flash is required, the camera will only respond to the ML-L3
shutter-release button once the flash has charged.
In auto or scene modes in which the flash
pops up automatically, the flash will begin charging when a remote control mode is
selected; once the flash is charged, it will automatically pop up and fire when required.
In flash modes that support red-eye reduction, the red-eye reduction lamp will light for
about one second before the shutter is released in quick-response remote mode.
In delayed
remote mode, the self-timer lamp will light for two seconds, followed by the red-eye
reduction lamp which lights for one second before the shutter is released.
A See Also
For information on choosing the duration of the self-timer and the number of shots taken,
see the Self-timer option in the setup menu (0 141).
For information on choosing how
long the camera will wait for a signal from the remote, see the Remote on duration option
in the setup menu (0 141).
For information on controlling the beeps that sound when the
self-timer and remote control are used, see the Beep option in the setup menu (0 141).
DK-20 rubber eyecup DK-5 eyepiece cap
q w
To Next Page
Loading...
