21
More on Movies
The Movie i‑Button Menu
Pressing the i button in movie mode
displays the following options:
• Choose image area: Choose an image area
for movie recording (page 9).
• Frame size/frame rate: Select a frame size
and rate (page 8).
• Active D‑Lighting: Adjust Active D-Lighting for movies recorded at
frame sizes other than 3840× 2160 (page 8).
• Movie quality: Choose movie quality.
• Microphone sensitivity: Press 1 or 3 to adjust microphone sensi-
tivity (page 13).
• Frequency response: Control the frequency response of the built-in
microphone (page 13).
• Wind noise reduction: Enable or disable wind noise reduction using
the built-in microphone’s low-cut filter (page 14).
• Destination: When two memory cards are inserted, you can
choose the card to which movies are recorded.
• Monitor brightness: Press 1 or 3 to adjust monitor brightness (note
that this affects live view only and has no effect on photographs or
movies or on the brightness of the monitor for menus or playback).
• Multi‑selector power aperture: Select Enable to enable power ap-
erture. Press 1 to widen the aperture, 3 to narrow the aperture.
• Highlight display: Choose whether the brightest areas of the frame
(highlights) are shown by slanting lines in the display.
• Headphone volume: Press 1 or 3 to adjust headphone volume.
• Electronic VR: Enable or disable electronic vibration reduction in
movie mode (page 20).
l
i button