Nikon D5100 - Page 45

Using.the Built-in Flash
The camera supports a variety of flash modes for photographing poorly lit or backlit
subjects.
•• Using the Built-in Flash:~, 2, ·S·, ~, rt ~, tW, and ~ Modes
1 Choose a flash mode (CD 38).
2 Take pictures.
The flash will pop up as required when the
shutter-release button is pressed halfway, and
fire when a photograph
is taken. If the flash does
not pop up automatically, DO NOT attempt to raise it
by hand. Failure to observe this precaution could
damage the flash.
•• Using the Built-in Flash: P, S, A, M, and T' Modes
1 Raise the flash.
Press the ~ button to raise the flash.
2 Choose a flash mode (P, S, A, and Mmodes
only; CD 38).
3 Take pictures.
The flash will fire whenever a picture is taken.
~ button
• Lowering the Built-in Flash
To save power when the flash is not in use, press it gently downward
until the latch clicks into place.
37