25
lamp, handle it through a piece of cloth or through its packaging
until replacement is complete. If you get fingerprints on the lamp,
wipe gently with a piece of clean cloth dampened with alcohol.
2
Attaching G-LS to the stand [C-PS & C-PSC]
Set so that the protrusion on the lamp house
aligns with the inside of the screw hole on the
arm of the stand (screw hole for mounting
6V10W halogen illuminator) and secure it in
place from the outside of the arm using the
mounting screw.
3
Arm for halogen illuminators
It is possible to freely adjust the direction of illumination by using a
special arm.
1 G-EIA flexible arm [G-LS]
Set so that the protrusion on the lamp
house aligns with the inside of the hole
in the holder of the flexible arm and
secure it in place from the outside of the
holder using the mounting screw.
Secure by screwing the mounting screw
supplied with the arm into the arm
mounting screw hole in the stand (screw
hole for mounting an Epi-arm).
Mounting
screw
G-LS
Screw hole for
mounting 6V10W
halogen illuminator
Mounting screw
Arm
Holder
Protru-
sion
G-LS
V
Flexible arm
Mounting screw
Illuminator
To Next Page
Loading...
