What to do if my Niles SI-275 will not turn on?
If your Niles Amplifier doesn't turn on, ensure the AC power cord is properly plugged into a working outlet and that the master power switch is turned on.
Why is there a hum coming from the speakers connected to my Niles SI-275?
If you are experiencing hum from the speakers connected to your Niles Amplifier, it might be due to a ground loop between components. Try reversing the AC plugs of each component in your system to test for this. Also, check for faulty cables, source material, an ungrounded phono system, or a defective component.
What to do if there is no sound on one channel of my Niles Amplifier?
If you have no sound on one channel of your Niles Amplifier, check the connections at the speaker or amplifier terminals for short circuits or loose wires. Ensure connections are secure and no wire strands cross from positive to negative terminals. Disconnect the speaker wire at both ends, separate the conductors, and test with a meter for shorts. If no short is found, connect the conductors at one end and test for continuity. You can also connect the speaker to a channel that plays another speaker. Finally, try connecting another audio cable that is known to be good.
Why does the bass sound weak and the stereo image blurry with my Niles SI-275?
If you experience weak bass and a blurry stereo image in one room with your Niles Amplifier, the loudspeakers might be wired out of phase. To correct this, reverse the connections at the back of one speaker.
What to do if there is no sound on both channels of my Niles SI-275?
If there is no sound on both channels of your Niles Amplifier, the audio cable to the main inputs could be faulty. Try connecting another cable that is known to be good.
To Next Page
General
