15
10.2 Service/maintenance guide - CV 20, CV 25, CV 35i
Dust
container
Should be emptied
before the container
is 3/4 full, depen-
ding on use but
normally 2-4 times
a year.
Danger of
blockage in the
pipe system.
Loosen the handles on the container (pull handle
outwards from the machine) to free the container from
the machine. Lift out the fi lter and dust bag - see addi-
tional information below. Empty the dust into a plastic
bag and put in dust bin. Any remaining dust or fl uff can
be removed manually.
Dust bag Should be replaced
before it becomes
completely full, de-
pending on use but
normally 2-4 times
a year.
Poor suction
and danger
of creating a
blockage
in the pipe
system.
Loosen the handles on the container (pull out from the
machine) to free the container from the machine. Lift
off the container. Lift out the fi lter. Then remove the
dust bag by pulling the bag’s cardboard stiffener off
the nozzle.
Replace in reverse order.
Should be shaken
when the container
is emptied.
NB: Only use dry
cleaning methods
To maintain
good suction
power.
Filter
NB! Never vacuum without a bag fi lter installed.
Loosen the handles on the container by pulling the
handles in an outward direction from the machine.
Remove the container from the machine.
Do not remove the fi lter from the container. Instead,
give the fi lter a light shaking inside the container to
loosen dust from the fi lter and allow it to fall into the
container.
Lift out the bag fi lter. If a dust bag is being used - re-
move it. Then empty the dust from the container in a
suitable place.
Should be replaced
before it becomes
completely full, de-
pending on use but
normally 2-4 times a
year.
Poor suction and
danger of
creating a
blockage in
the pipe system.
Dust bag Grasp the edge of the lid and open it by pulling up-
wards. Remove the old dust bag by turning the card-
board stiffener to the right or left so that the elevation
on the nozzle penetrates the opening in the cardboard.
Now slide the bag off the inlet. Push the opening in
the cardboard over the elevation on the inlet and pull
on the new bag. Twist the cardboard to lock the bag in
place. NB! The opening in the card must be adjusted
and pushed past the elevation on the inlet before the
cardboard can be locked into place with a twisting
action.
NB! Never vacuum without a dust bag installed.
Filter in the
bottom of
the cleaner
Should be checked
when changing
the bag.
Poor suction
can result. Dust
can fi nd its way
into the motor.
10.1 Service/maintenance guide - CV 10
Remove the dust bag as described above. Remove
the fi lter from the bottom. The fi lter can be cleaned by
shaking it or washing it in water. NB! The fi lter must be
completely dry before being reinstalled. Press the outer
edge of the fi lter down against the sides of the contai-
ner so that the fi lter bulges up slightly. Then push the
fi lter down into place. Make sure the fi lter is packed
in tightly against the motor housing. Refi t the dust bag
and replace the lid. Check that the lid is sitting fi rmly in
place. NB! Never vacuum without a fi lter installed.
NB! Never vacuum without a fi lter and dust bag installed in the CV 10 unit.
Product How often? Why? How?
Product How often? Why? How?
To Next Page
Loading...
Need help?
General
