Nilfisk-Advance SC100 Operating Guidelines

Nilsk A/S
Banemarksvej 58,
DK-2605 Broendby
DENMARK
Tel.: +45 43 23 40 50
Fax: +45 43 43 77 00
mail.com@nilsk.com
www.nilsk.com
The machine
doesn’t work
as it should?
The suction
doesn’t work
as it should?
The machine
doesn’t clean
as it should?
The brush
doesn’t work
as it should?
TROUBLESHOOTING
SC100
1. Check if the power supply cable is
damaged, faulty or disconnected
from the electrical mains.
1. Check if the recovery tank is full.
1. Check if you have the right
detergent solution settings or the
solution tank is empty.
2. The main switch is broken. (*)
2. Check if the squeegee bars are
dirty or the blades are worn or
damaged.
2. Check if the solution lter is dirty.
Clean it if needed.
1. Check if the cylindrical brush is
correctly installed and not worn out.
3. The push button panel is broken. (*)
(*) For these causes the maintenance
procedure must be performed by an
authorised Nilsk Service Center.
For further information refer to the
Service Manual, available at any
Nilsk Service Center.
3. Check if the inspection
compartment is dirty.
3. Check if the holes in solution
dispensers are clogged. Remove
them and clean if needed.
4. Check if the recovery vacuum hose
is disconnected or dirty.
ATTENTION! Do not use the machine before you have read and understood the Instructions for use manual.
ScrubVac
01309 676796
sales@scrubvac.co.uk
www.scrubvac.co.uk

Nilfisk-Advance SC100 Specifications

General

Brand	Nilfisk-Advance
Model	SC100
Category	Vacuum Cleaner
Language	English