To Next Page
S
susanwalshAug 12, 2025
Why is my Nilfisk-Advance SOL 3 leaking dust?
- KKimberly ShawAug 12, 2025
If dust leaks from your Nilfisk-Advance Vacuum Cleaner, the filter is likely torn. Replace it with a filter of identical category.
Why is my Nilfisk-Advance SOL 3 leaking dust?
If dust leaks from your Nilfisk-Advance Vacuum Cleaner, the filter is likely torn. Replace it with a filter of identical category.
Why does my Nilfisk-Advance SOL 3 suddenly stop?
If your Nilfisk-Advance Vacuum Cleaner suddenly stops, there are several potential causes. First, the main filter might be clogged; try shaking it, and if that doesn't work, replace it. Second, the vacuum hose could be clogged, so inspect and clean it thoroughly. Finally, the circuit breaker may have been activated. In this case, check the setting, check the motor electrical input and empty the container. If problems persist, contact an authorized after-sales service center.
What to do if my Nilfisk-Advance SOL 3 Vacuum Cleaner does not start after emptying the container?
If your Nilfisk-Advance Vacuum Cleaner doesn't start after emptying the container, the level monitoring hose might be clogged. To resolve this, release the container and clean the level sensor.
How to fix electrostatic current on my Nilfisk-Advance SOL 3?
If you're experiencing electrostatic current on your Nilfisk-Advance Vacuum Cleaner, it's likely due to nonexistent or inefficient grounding. Check all ground connections, paying special attention to the inlet. Ensure that the hose is strictly antistatic.
General| Cable length | 10 m |
|---|---|
| Rated power | 1200 W |
| Airflow | 3600 l/min |
| Hose length | 2.5 m |
| Frequency | 50 Hz |
| IP protection class | IPX4 |
| Vacuum | 220 mbar |
