Nilfisk A/S
Kornmarksvej 1
DK-2605 Brøndby
Denmark
Tel.: +45 43 23 40 50
Fax: +45 43 43 77 00
mail.com@nilfisk.com
www.nilfisk.com
If the machine has been used until the red light illuminates on the battery level indicator on the machine, a full recharge of the batteries (10-12 hours) will be required. Failure to carry out this this
procedure may cause damage to the batteries. Charging the batteries after every use is recommended.
Use & maintenance
- SC430
17. Park the machine with the recovery
tank cover open.
16. Charge the batteries: Connect the
battery charger cable to the mains
electricity supply.
15. Clean the machine using a damp
cloth and where needed use a
neutral cleaning product.
14. Check and clean the squeegee
blades.
10. Wash with clean water the recovery
tank and the vacuum grid.
11. Remove the brush/pad and clean
them.
12. Take the squeegee off and remove
debris.
13. Check and clean the squeegee
blades.
5. Place the brush or the pad-holder
under the deck. Use the appropriate
brush to clean the floor.
9. At the end of the work. Empty the
recovery tank with the hose. Then
empty the solution tank with the
trasparent hose.
6. Adjust the eco solution flow control
valve.
8. Press the handle switch to engage
the brush and run the machine.
7. Switch on the brush and vac motors
to activate the machine.
2. Fill the tank with a clean water. The
clean water temperature must not
exceed 40 °C.
1b. Disconnect the battery charger
cable from the mains electricity
supply.
3. If the squeegee is not connected to
the machine: install and fasten it with
the handwheels, then connect to the
suction hose.
1a. Switch off charger by unplug
charger cable from red battery plug.
Reconnect the red battery plug to
the machine.
.
4. If the squeegee is in upper position,
lower it with the lever.
ATTENTION! Do not use the machine before you have read and understood the Instructions for User Manual
To Next Page
Loading...
