Nilfisk-ALTO ATTIX 30 / PC / XC User Manual (English)

Other manuals for Nilfisk-ALTO ATTIX 30 / PC / XC

Questions and Answers:

C
Chelsea LambertAug 16, 2025
Why won't my Nilfisk-ALTO Vacuum Cleaner motor start?
- S
  Stephanie LevineAug 16, 2025
  If your Nilfisk-ALTO Vacuum Cleaner motor won't start, it could be due to a blown fuse in the mains socket. Try connecting a mains fuse. Another possibility is that the overload protection switch has tripped. In this case, switch off the vacuum cleaner and allow it to cool for approximately 5 minutes. If it still doesn't start, contact the Nilfisk-Alto service department. Finally, the motor itself might be faulty, so have it changed by Nilfisk-Alto Service.
R
Richard GarciaAug 22, 2025
Why is my Nilfisk-ALTO ATTIX 30 / PC / XC Vacuum Cleaner causing voltage fluctuations?
- A
  Ashley DuranAug 22, 2025
  Voltage fluctuations in your Nilfisk-ALTO Vacuum Cleaner can occur if the impedance of the power supply is too high. Try connecting the cleaner to another socket closer to the fuse box. Voltage fluctuations over 7% should not occur if the impedance at the transfer point is ??0.15 ??.
K
Kyle MyersAug 26, 2025
What to do if Nilfisk-ALTO ATTIX 30 / PC / XC motor doesn't run in automatic mode?
- G
  Grant MooreAug 26, 2025
  If your Nilfisk-ALTO Vacuum Cleaner motor doesn't run in automatic mode, it could be because the power tool/pneumatic tool is defective or not connected properly. Check that the power tool works or that the plug is inserted correctly. Also, the power rating of the electrical tool might be too low; ensure it's above the minimum power rating of P>40W.
S
Sheila WallAug 28, 2025
Why does my Nilfisk-ALTO Vacuum Cleaner have no suction power during wet cleaning?
- J
  Jenna Gibbs DDSAug 28, 2025
  If your Nilfisk-ALTO Vacuum Cleaner has no suction power during wet cleaning, it's likely that the tank is full. Switch off the cleaner and empty the tank.
J
Joseph HobbsAug 31, 2025
Why Nilfisk-ALTO ATTIX 30 / PC / XC Vacuum Cleaner has reduced suction power?
- M
  Melinda BrownAug 31, 2025
  Reduced suction power in your Nilfisk-ALTO Vacuum Cleaner can occur for several reasons: * The suction power setting might be too low; adjust it according to the instructions. * The suction hose or nozzle may be clogged; clean them. * The tank, disposal bag, or filter bag might be full; empty the tank or replace the bags. * The filter element could be clogged; clean or replace it. * The seal between the tank and the upper section of the vacuum cleaner may be faulty or missing; replace the seal. * The cleaning mechanism might be defective, in which case you should contact Nilfisk-Alto Service.
R
Ronald MasonSep 3, 2025
What to do if my Nilfisk-ALTO Vacuum Cleaner motor does not start?
- K
  Kristin SanchezSep 3, 2025
  If the motor of your Nilfisk-ALTO Vacuum Cleaner fails to start, there are a few potential causes: * The fuse in the mains socket may have blown; connect a mains fuse. * The overload protection switch may have tripped; switch off the vacuum cleaner and allow it to cool for approximately 5 minutes. If it still doesn't start, contact Nilfisk-Alto service. * The motor itself might be faulty; have it changed by Nilfisk-Alto Service.
J
John HessSep 6, 2025
What to do if my Nilfisk-ALTO Vacuum Cleaner has no suction power during wet cleaning?
- M
  Matthew HarrisSep 6, 2025
  If your Nilfisk-ALTO Vacuum Cleaner lacks suction power during wet cleaning, it's likely that the tank is full. To resolve this, switch off the cleaner and empty the tank.
A
Alicia HarrisSep 9, 2025
Why Nilfisk-ALTO ATTIX 30 / PC / XC Vacuum Cleaner motor does not run in automatic mode?
- W
  woodwardanthonySep 9, 2025
  If the motor of your Nilfisk-ALTO Vacuum Cleaner does not run in automatic mode, it could be due to the following reasons: * The power tool or pneumatic tool is defective or not connected properly; ensure the power tool works and the plug is correctly inserted. * The power rating of the electrical tool is too low; make sure the minimum power rating is above 40W.
J
Jeffrey BeckSep 10, 2025
How to restore suction power in my Nilfisk-ALTO ATTIX 30 / PC / XC Vacuum Cleaner?
- B
  Brittany RoachSep 12, 2025
  Reduced suction power in your Nilfisk-ALTO Vacuum Cleaner can be due to several reasons. The suction power may be set too low, adjust it accordingly. The suction hose or nozzle might be clogged, so clean them. The tank, disposal bag, or filter bag could be full; empty the tank or replace the bags. The filter element might be clogged, so clean or replace it. A faulty or missing seal between the tank and upper section could also be the cause, replace the seal in this case. Finally, the cleaning mechanism could be defective, contact Nilfisk-Alto Service.
R
Raymond ClaytonSep 12, 2025
How to fix voltage fluctuations in Nilfisk-ALTO Vacuum Cleaner?
- U
  uthompsonSep 12, 2025
  To address voltage fluctuations with your Nilfisk-ALTO Vacuum Cleaner, connect the cleaner to another socket closer to the fuse box. Voltage fluctuations over 7% should not occur if the impedance at the transfer point is ? 0.15 ?.

Nilfisk-ALTO ATTIX 30 / PC / XC Specifications

General

Model	ATTIX 30 / PC / XC
Category	Wet & Dry Vacuum Cleaner
Power Piec	1200 W
Airflow	3700 l/min
Container Volume	30 l
Weight	7.5 kg
Cord Length	7.5 m
Hose Length	2.5 m
Mains connection	220-240 V