Nilfisk-ALTO ATTIX 350-0H

Questions and Answers

K
Kenneth HigginsAug 16, 2025
What to do if my Nilfisk-ALTO ATTIX 350-0H Vacuum Cleaner motor does not start?
- J
  James JonesAug 16, 2025
  If the motor of your Nilfisk-ALTO Vacuum Cleaner doesn't start, it could be due to a few reasons: * The fuse of the mains socket may have blown. In this case, connect the mains fuse. * The overload protection switch might have tripped. Switch off the vacuum cleaner, let it cool down for about 5 minutes. If it still won't start, contact the Nilfisk-Alto service department. * The self-acting carbon brush may be worn. Have the carbon brushes changed by Nilfisk-Alto Service.
R
Roy GreenAug 20, 2025
What to do if my Nilfisk-ALTO ATTIX 350-0H Vacuum Cleaner switches off during wet cleaning?
- A
  Adam BerryAug 21, 2025
  If your Nilfisk-ALTO Vacuum Cleaner turns off during wet cleaning, it's likely because the tank is full. Switch off the cleaner and empty the tank.
C
Charlotte CoxAug 26, 2025
Why Nilfisk-ALTO Vacuum Cleaner motor does not run in automatic mode?
- A
  Andrea MontgomeryAug 26, 2025
  If the Nilfisk-ALTO Vacuum Cleaner motor isn't running in automatic mode, it could be because: * The power tool is defective or not connected properly. Ensure the power tool works and the plug is correctly inserted. * The power rating of the electrical tool is too low. The minimum power rating should be P>40W.
A
Alexander KnightAug 30, 2025
What to do if there is no suction power during wet cleaning with my Nilfisk-ALTO ATTIX 350-0H?
- S
  Stacey DaviesAug 30, 2025
  If you're experiencing no suction power during wet cleaning with your Nilfisk-ALTO Vacuum Cleaner, the tank is likely full, preventing the float from closing the suction opening. To resolve this, switch off the cleaner and empty the tank.
K
Kevin HutchinsonSep 5, 2025
Why am I experiencing voltage fluctuations with my Nilfisk-ALTO ATTIX 350-0H?
- M
  mclaughlinkatelynSep 5, 2025
  Voltage fluctuations with your Nilfisk-ALTO Vacuum Cleaner can occur if the impedance of the power supply is too high. Try connecting the cleaner to another socket closer to the fuse box. Voltage fluctuations should not exceed 7% if the impedance at the transfer point is ? 0.15 ?.
H
hannahheathNov 10, 2025
Why is my Nilfisk-ALTO Vacuum Cleaner losing suction and making acoustic warnings?
- M
  Maria CaseyNov 10, 2025
  The acoustic warning and reduced suction power in your Nilfisk-ALTO Vacuum Cleaner can be due to several reasons: * The suction power may be set too low; adjust it according to section 4.2.3, „Setting suction power“. * The hose diameter might not match the switch position; adjust the switch position to match the hose diameter. * The suction hose or nozzle could be clogged; clean the hose and nozzle. * The safety filter bag might be full; replace the filter bag according to section 7.2.2, „Replacing filter bag“. * The filter element could be clogged; clean it as described in section 4.5 „Cleaning filter element“ or replace it as described in section 7.2.3 „Replacing filter element“. * For ATTIX 560-2HXC models only: there may be a defective cleaning mechanism; contact Nilfisk-A...