How to fix voltage fluctuations in Nilfisk-ALTO ATTIX 30 H Vacuum Cleaner?
To address voltage fluctuations with your Nilfisk-ALTO Vacuum Cleaner, connect the cleaner to another socket closer to the fuse box. Voltage fluctuations over 7% should not occur if the impedance at the transfer point is ? 0.15 ?.
How to fix a Nilfisk-ALTO Vacuum Cleaner when the motor does not start?
If your Nilfisk-ALTO Vacuum Cleaner motor doesn't start, it could be due to a blown fuse. Connect the mains fuse. Alternatively, the overload protection switch may have tripped. In this case, switch off the vacuum cleaner and allow it to cool for approximately 5 minutes. If it still won't start, contact Nilfisk-Alto service. Finally, the motor itself may be faulty, and you should have it changed by Nilfisk-Alto Service.
Why is my Nilfisk-ALTO Vacuum Cleaner causing voltage fluctuations?
If you experience voltage fluctuations with your Nilfisk-ALTO Vacuum Cleaner, it may be due to high impedance in the power supply. To resolve this, connect the cleaner to another socket closer to the fuse box. Voltage fluctuations should not exceed 7% if the impedance at the transfer point is ≤ 0.15 Ω.
What to do if Nilfisk-ALTO Vacuum Cleaner has no suction power during wet cleaning?
If your Nilfisk-ALTO Vacuum Cleaner has no suction power during wet cleaning, it could be that the tank is full. Switch off the cleaner and empty the tank.
Why Nilfisk-ALTO ATTIX 30 H motor does not run in automatic mode?
If the motor of your Nilfisk-ALTO Vacuum Cleaner does not run in automatic mode, check that the power tool works or that the plug is inserted correctly. Also, ensure that the power rating of the electrical tool is greater than 40W.
Why won't my Nilfisk-ALTO ATTIX 30 H Vacuum Cleaner motor start?
If your Nilfisk-ALTO Vacuum Cleaner motor won't start, it could be due to a blown fuse in the mains socket. Try connecting a mains fuse. Another possibility is that the overload protection switch has tripped. In this case, switch off the vacuum cleaner and allow it to cool for approximately 5 minutes. If it still doesn't start, contact the Nilfisk-Alto service department. Finally, the motor itself might be faulty, so have it changed by Nilfisk-Alto Service.
Why is my Nilfisk-ALTO ATTIX 30 H Vacuum Cleaner acoustic warning sounding and suction power reduced?
The acoustic warning and reduced suction power in your Nilfisk-ALTO Vacuum Cleaner can be due to several reasons. The suction power selected might be too low, so adjust it accordingly. Ensure the hose diameter corresponds with the switch position. Check for a clogged suction hose or nozzle and clean them if necessary. Also, verify if the tank, disposal bag, or filter bag is full, and empty or replace them as needed. A clogged filter element could also be the cause; clean or replace it. Inspect the seal between the tank and the upper section of the vacuum cleaner for faults or if it's missing, and replace it if needed. If the cleaning mechanism is defective, contact Nilfisk-Alto Service.
How to resolve voltage fluctuations in my Nilfisk-ALTO ATTIX 30 H?
To address voltage fluctuations in your Nilfisk-ALTO Vacuum Cleaner, the impedance of the power supply might be too high. Try connecting the cleaner to another socket closer to the fuse box. Voltage fluctuations over 7% should not occur if the impedance at the transfer point is ??0.15 ??.
What to do if my Nilfisk-ALTO Vacuum Cleaner has no suction power during wet cleaning?
If your Nilfisk-ALTO Vacuum Cleaner lacks suction power during wet cleaning, it's likely that the tank is full. To resolve this, switch off the cleaner and empty the tank.
Why Nilfisk-ALTO ATTIX 30 H has reduced suction power?
Reduced suction power in your Nilfisk-ALTO Vacuum Cleaner can occur for several reasons: * The suction power setting might be too low; adjust it according to the instructions. * The suction hose or nozzle may be clogged; clean them. * The tank, disposal bag, or filter bag might be full; empty the tank or replace the bags. * The filter element could be clogged; clean or replace it. * The seal between the tank and the upper section of the vacuum cleaner may be faulty or missing; replace the seal. * The cleaning mechanism might be defective, in which case you should contact Nilfisk-Alto Service.
General| Brand | Nilfisk-ALTO |
|---|---|
| Model | ATTIX 30 H |
| Category | Vacuum Cleaner |
| Language | English |
To Next Page