11
1)
Options / model variants
NEPTUNE 2
6.1 Switching off
the cleaner and
disconnecting supply
lines
6 After using the cleaner
6.2 Rolling up the electrical
lead and storing
accessories
To prevent accidents, always
carefully roll up the electri-
cal lead and the high pressure
hose.
Place the spray lance into the
storage position.
6.3 Storing the cleaner
(below 0°C)
Store the cleaner in a dry room
without danger of frost or protect
as below:
1. Remove the water inlet hose
from the cleaner.
2. Remove the spray lance.
3. Switch on the cleaner with
the main switch in position
"Cold Water".
4. Operate the spray gun.
5. Open the cover (A)
6. Gradually pour antifreeze
(approx. 5 litres) into the wa-
ter tank.
7. During suction operate
the spray gun two or three
times.
8. The machine is protected
against frost when antifreeze
solution emerges from the
spray gun.
9. Lock the safety catch on the
spray gun.
10.Close the cover
11. Switch off the cleaner.
12. To avoid any risks, store the
cleaner temporarily in a heat-
ed room in upright position.
13. When the machine is put into
service again, the antifreeze
solution can be collected and
stored for future use.
Close water tap1.
Activate spray gun without 2.
lance in order to empty all
residual water in the system
Turn the main switch to posi-3.
tion „OFF“.
Pull out the plug from the 4.
electrical socket.
Squeeze the spray gun han-5.
dle until the cleaner is de-
pressurised.
Lock the safety catch on the 6.
spray gun.
Remove the water hose from 7.
the cleaner.
A
6.4 Transporting the
cleaner
The machine can be in either
upright position or tilted position
during transportation.
Use the fi xing points (B) when
securing with belts.
Notice the risk of leaking water by
sudden heavy movements during
transportation.
B
B
To Next Page
Loading...
Need help?
General
