5
1)
Options / model variants
NEPTUNE 2
0
300
CUT OUT
1
°F
210
80
85
°C
175
105
120
60
140
70
160
90
195
100
30
40
50
0
2%
1%
3%
4%
2.2 Operating elements High pressure hose reel1.
1)
Top cover release2.
Cannister for detergent3.
Cable hook4.
Spray lance5.
Supply water connection6.
Spray lance storage7.
Hose hook8.
Tank filler for fuel9.
High pressure hose connection 10.
for machines without hose
reel
Control panel11.
Power ON12.
Fuel low13.
1)
Nilfisk-ALTO AntiStone low14.
1)
Service interval due/expired15.
Boiler overheated16.
Flame sensor is sooted17.
Main switch18.
Temperature controller19.
Detergent metering knob20.
1)
3 Before starting the cleaner
3.1 Setting up the cleaner Every fuel-burning appliance,
such as pressure washers, de-
pends upon a proper mix of fuel
and air (by weight) for proper
combustion. Therefore some
adjustment of the air regulation
to the burner may be necessary
to take account of altitude and
the resulting air pressure. This
is true whether your fuel is Ker-
osene or Diesel.
Your Nilfisk-ALTO hot water
pressure washer was thor-
oughly tested and adjusted for
optimum performance before
it left our factory. The factory is
located at approximately 140m
(450 ft) above sea level, and the
combustion settings are optimal
for that elevation.
If your location is higher than
1200m (3900 ft) above sea
level, your burner may require
re-adjustment for proper per-
formance and best fuel econ-
omy. Contact your Dealer or
Nilfisk-ALTO for assistance.
3.2 Before use 1. Before using the cleaner for
the first time, check it care-
fully to detect any faults or
damage.
2. Run the machine only when
it is in perfect condition.
3. The slope on which the high
pressure cleaner is placed
must not exceed more than
10
o
in any direction.
See fold-out page at front of these
operating instructions.
3.3 Fill up detergent tank
1)
1. Fill up detergent tank with
prediluted detergent.
Capacity see chapter 9.3 Tech-
nical Data
Max 10
°
To Next Page
Loading...
Need help?
General
