Nilfisk cfm VHW321 User Manual

C393
6
09/2014
VHW320 - VHW321 - VHW420 - VHW421 - VHW440
GB
Packing and unpacking
Dispose of the packing materials in compliance with the laws
in force.
Figure 3
VHW320 MODEL
A
(mm)
B
(mm)
C
(mm)
kg
L - M - H 500 900 1360 86
ATEX Z22 500 900 1360 86
ATEX Z2 500 900 1360 91
IC 500 900 1630 107
VHW321 MODEL
A
(mm)
B
(mm)
C
(mm)
kg
L - M 500 900 1360 91
H 500 900 1360 96
ATEX Z21 500 900 1360 99
ATEX Z22 500 900 1360 91
ATEX Z2 500 900 1360 96
VHW420 MODEL
A
(mm)
B
(mm)
C
(mm)
kg
STD 620 1050 1660 121
ATEX Z22 620 1050 1660 121
IC 620 1050 1950 153
C 620 1050 1950 162
VHW421 MODEL
A
(mm)
B
(mm)
C
(mm)
kg
L - M 620 1050 1660 136
H 620 1050 1660 139
ATEX Z21 620 1050 1660 149
ATEX Z22 620 1050 1660 136
VHW440 MODEL
A
(mm)
B
(mm)
C
(mm)
kg
STD 620 1050 1660 134
IC 620 1050 1950 165
C 620 1050 1950 175
Unpacking, moving, use and storage
Operate on at, horizontal surfaces.
The load-bearing capacity of the surface the vacuum cleaner
is placed on must be suitable for bearing its weight.
Setting to work - connection to the power
supply
WARNING!
■ Make sure there is no evident sign of damage to
the vacuum cleaner before starting work.
■ Before plugging the vacuum cleaner into the
electrical mains, make sure the voltage rating
indicated on the data plate corresponds to that of
the electrical mains.
■ Plug the vacuum cleaner into a socket with a
correctly installed ground contact/connection.
Make sure that the vacuum cleaner is turned off.
■ The plugs and connectors of the power supply
cords must be protected against splashes of water.
■ Check for proper connection to the electrical
mains.
■ Use the vacuum cleaner only when the cord
that connects to the electricity mains is in good
condition (damaged cords could lead to electric
shock!).
■ Regularly check there are no signs of damage,
excessive wear, cracks or aging on the electric
cord.
WARNING!
When the device is operating, do not:
■ Crush, pull, damage or tread on the cord that
connects to the electrical mains.
■ Only disconnect the cord from the electrical mains
by removing the plug (do not pull the cord).
■ Only replace the electric power supply cord with
one of the same type as the original: FROR, the
same rule applies if an extension is used.
■ The cord must be replaced by the manufacturer’s
Service Center staff or by equivalent qualied
personnel.

Nilfisk cfm VHW321 Specifications

General

Brand	Nilfisk cfm
Model	VHW321
Category	Vacuum Cleaner
Language	English