10
42445 Avenida Alvarado, Temecula, CA 92590
(800) 451-9343, www.nimbuswater.com
1. System is located where it will not be subject to physical impacts or rough contact by heavy objects.
2. Feed water pressure to the unit is no less than 40 psi and no greater than 80 PSI.
3. All tubing connec ons, especially push-in quick connec ons, are fully inserted.
4. Tubing connected between the faucet and the drain saddle fi ng (the fi ng a ached to the sink drain pipe) runs
"downhill" to the drain. There should be no loops or places where water would not fl ow out to the drain.
5. Feed water valve is open.
6. Within one to two hours a er ini al applica on of water pressure, check again for leaks especially at the tank, faucet
tubing and connectors. These parts will not see full pressure un l approximately 2 hours a er the system is ac vated.
7. Flush three tankfuls of product water to drain. If a chlorine scent persists, repeat fl ushing procedure.
CS-2 Installa on Checklist
To Next Page
Loading...
Need help?
General
