04 05
1. The Ninebot Z10 is a recreational transporter. Before mastering riding skills, you need to practice.
Neither Ninebot Inc. (means Ninebot(Beijing)TechCo.,Ltd. and its subsidiaries and affiliates) nor
Segway Inc. is responsible for any injuries or damage caused by a rider's inexperience or failure to
follow the instructions in this document.
2. Please understand that you can reduce the risk by following all the instructions and warnings in this
manual, but you cannot eliminate all the risks. Remember that whenever you ride the Ninebot Z10 you
risk injury from loss of control, collisions, and falls. When entering into public spaces always comply
with the local laws and regulations. As with other vehicles, faster speeds require longer braking
distance. Sudden braking on low traction surfaces could lead to wheel slip, or falls. Be cautious and
always keep a safe distance between you and other people or vehicles when riding. Be alert and slow
down when entering unfamiliar areas.
3. Always wear a helmet when riding. Use an approved bicycle or skateboard helmet that fits properly
with the chin strap in place, and provides protection for the back of your head.
4. Do not attempt your first ride in any area where you might encounter children, pedestrians, pets,
vehicles, bicycles, or other obstacles and potential hazards.
5. Respect pedestrians by always yielding the right of way. When approaching a pedestrian from the
front, stay to the right and slow down. Avoid startling pedestrians. When approaching from behind,
announce yourself and slow down to walking speed when passing. Pass on the left whenever possible.
Please obey local traffic laws and regulations.
6. In places without laws comply with the safety guidelines outlined in this manual. Neither Ninebot Inc.
nor Segway Inc. is responsible for any property damage, personal injury/death, accidents, or legal
disputes caused by violations of the safety instructions.
7. Do not allow anyone to ride your Ninebot Z10 on his/her own unless they have carefully read this
manual and followed the New Rider Tutorial in the App. The safety of new riders is your responsibility.
Assist new riders until they are comfortable with the basic operation of the Ninebot Z10. Make sure
each new rider wears a helmet and other protective gear.
8. Before each ride check for loose fasteners and damaged components. If the Ninebot Z10 makes
abnormal sounds or signals an alarm, immediately stop riding. Diagnose your Ninebot Z10 via the
Segway-Ninebot App and call your dealer/distributor for service.
Mainframe
WrenchBattery Charger
User Manual
Trolley HandleFender
Welcome Card
Welcome Card
When unpacking your Ninebot Z10, please verify that the above items are included in the package. If you are missing
any components, please contact your dealer/distributor or visit website: www.segway.com.
2 Product and Accessories
User Manual
Screw ×2 Valve Stem Extension
3 Assembling
(according to personal preference)
1
4
2
5
3
Spacer
Remove ten screws as
shown in the figures, then
the spacers (two pieces)
from the vehicle body.
Position the screw holes on
both sides of the accessory
holder into the corresponding
places of the vehicle body.
Tighten the appropriate
screws as shown in the figure
to complete the installation
of the trolley handle.
Push in the fender to
correspond with the
previous spacer position.
Tighten the same screws
as shown in the figure to
complete the installation
of the fender.
Tips:
1. Two screws used for
tightening the top side of the
fender are included in the
accessory box.
2. According to your personal
preference, you can choose
to install only the fender or
the trolley handle.
To Next Page
Loading...
Need help?
General
