06 07
Handle
Power Switch
Pedals
4 Diagram
Dashboard
[1]
Dashboard ：
Charging Port
Headlight
Wheel
Rear
Light
Bluetooth
Speed Limit
Power Level
Bluetooth
Speed
Limit
Power
Switch
Power on/off
Power
Level
[1] The dashboard contains a light sensor, please do not block or cover it so the light can turn on/off automatically.
Portable Mode
Ninebot Z10 is set to portable mode when the vehicle is
delivered. If you lift the handle when the vehicle is
powered on, the wheels will stop turning. The vehicle
will run normally when you reset the handle.
You can switch off portable mode on the phone app. If
you do, do not lift the handle when the vehicle is
powered on, or the wheels will still turn and may cause
injury.
Use of Trolley Handle
After the installation of the trolley handle to Ninebot
Z10, the handle can be pulled out to move the vehicle in
non-riding state, and the handle can be pulled back
after use.
Note:
Do not lift the vehicle up directly by the trolley handle.
Do not use the trolley handle while riding.
Note:
Pick up the vehicle only by the handle .
A blinking Bluetooth icon indicates that the Bluetooth is turned on but not connected to the mobile
phone; an illuminated Bluetooth icon indicates that the App is connected to the Ninebot Z10.
Each block represents 20% of power level. When the battery is nearly empty the icon blinks.
Please charge before use again. When the power level decreases to a certain level, your Ninebot
Z10 gradually reduces the speed limit to ensure safety. Use the App to read the remaining power
and estimated remaining range.
Speed Limit Mode can be used for the new rider to practice. Follow the instructions on the App to
activate your Ninebot Z10; the speed limit of the vehicle will be gradually increased. When the
Ninebot Z10 is in the safety state, the Speed Limit Mode will be turned on automatically, and the
vehicle will be limited to a lower speed. Users can customize the speed limit.
To Next Page
Loading...
Need help?
General
