NINGBO DAVID YP-90A - System Setting Procedures for Incubator Controller

SERVICE MANUAL FOR INFANT INCUBATOR EDITION/REVISION B/0
5-2
I2
5.3 SYSTEM SETTING PROCEDURES
5.3.1 GENERAL
This paragraph provides controller system setting procedure.
NOTICE: Please follow by the procedures of item 5.3.3. if it is unnecessary, please do not
change data of system setting to avoid hazards.
5.3.2 BRIEF INTRODUCTION
Controller system setting procedures listed below:
1. LED Lightness set
2. Air temperature sensor compensation
3. Air flow temperature sensor compensation
4. Skin temperature sensor compensation
5. Machine Number
6. Motor speed alarm value
7. Set value of Low deviation for air temperature
8. Set value of High deviation for air temperature
9. Set value of Low deviation for skin temperature
10. Set value of High deviation for skin temperature
11. Minimum set value of air temperature
12. Maximum set value of air temperature
13. Minimum set value of skin temperature
14. Maximum set value of skin temperature
15. Set value of Over temperature alarm (＜37 )℃
16. Set value of Over temperature alarm (＞37 )℃
17. Set value of air flow Over temperature alarm (＜37 )℃
18. Set value of air flow Over temperature alarm(＞37 )℃