- 20 -
Read instructions before lighting.
Set all 4 knobs to “OFF” position.
Connect propane cylinder (See Manual) and Open
lid during lighting.
Push in and turn the burner knobs counter clockwise
until it reaches the “Max” sign and a click sound is heard.
(Each burner is independent)
If ignition does not occur in 5 seconds, turn the burner
control(s) off, wait 5 minutes, and repeat the lighting procedure.
Adjust flame to desired flame with the control knobs.
Ensure the gas valve orifices must be correctly positioned inside the burner tube. If the
burner tube does not fit over the valve orifice, lighting the burner may causee explostion
and/or fire.
It is recommended to use a flashlight to view the correct position through the firebox vent
holes as illustrated below.
After checking, reattach each burner with the cotter pins and reattach the ignition wire to
the ignition pin by hand.
1.
2.
3.
4.
5.
6.
WARNING:
Read instructions before lighting.
If ignition does not occur in 5 seconds, turn the burner control(s) off.
Wait 5 minutes and repeat the lighting procedure.
Keep any electrical supply cord and the fuel supply hose away from any heated surfaces.
LIGHTING THE MAIN BURNERS USING ELECTRONIC IGNITIGN
Re-Installing Main Burners
View the correct position
from the bottom of the firebox
To Next Page
Loading...