- 27 -
Troubleshooting:
Problem
Possible cause Prevention/Solution
Burner will not match
light
See ”gas issues;” on
previous page.2.
Improper method of
match-lighting
See "Pilot Gas Control Ignition"
section of use and care.
Flames blow out
High or gusting winds.
Low on LP gas.
Excess fiow valve tripped.
Turn front of grill to face wind or
increase flame height.Refill LP
tank.Refer to "sudden drop in
gas flow" above.
Persistent grease fire
Grease trapped by food
buildup around burner
system.
Turn knobs to "OFF". Tum gas off
at LP tank.
Leave lid in position and let fire
burn out.
Alter grill cools, remove and clean
all parts.
Sudden drop in gas
flow or low flame
Flashback...
fire in burner tube(s)
Burner and burner
tubes are blocked
Turn knobs to "OFF". Clean
burner and/or burner tubes.
See burner cleaning section of
use and care manual
Unable to fill LP tank
Some dealers have
older fill nozzles with
worn threads.
Turn worn nozzles don’t have
enough "bite" to engage the valve.
Try a second LP dealer.
One burner does not
light from other burner(s)
Grease buildup or food
particles in end of
carryover tube.
Clean carry-over tube with
wire brush.
Flare-up
1.
2.
Glean burners and inside of
grill/ firebox
Trim fat from meet before grilling.
1.
2.
3.
Grease buildup.
Excessive fat in meat.
Excessive cooking
temperature
1.
2.
3.
Grease buildup.
Excessive fat in meat.
Excessive cool-ring
temperature
1.
2.
3.
Clean burners and inside of grill/
firebox.
Trim fat from meal before grilling.
Adjust (lower) temperature.
To Next Page
Loading...