USING THE DOUGH BLADE
IMPORTANT: Use only the “DOUGH”
button when using this attachment.
IMPORTANT: DO NOT attempt to use the
dough blade without using the suction
lever to secure the appliance to the
counter or table top first.
1 Place the motor base on a clean, dry,
level surface such as a counter or table
top. (Fig. 10) Push the suction lever on
the side of the base down to secure the
suction feet to the surface. (Fig. 10a) If
the suction feet have not totally adhered
to the surface, press down slightly on
the base to give the suction feet a better
grip.
2 Secure the bowl onto the motor base.
3 Holding the dough blade by the shaft,
place it onto the gear shaft inside the
bowl. Ensure that the attachment fits
around the gear shaft and that it is
standing straight.
USING THE 4-BLADE ASSEMBLY
1 Holding the 4-Blade assembly by the
shaft, place it onto the gear shaft inside
the bowl. Ensure that the attachment
fits around the gear shaft and that it is
standing straight.
2 Add the ingredients and secure the bowl
lid onto the bowl. (Fig. 9)
3 Plug the power cord into the electrical
outlet and press on the power button ( ).
NOTE: Please refer to “Speed Settings
& Uses” chart for suggested uses and
speeds.
Fig. 9
Fig. 10
Using the Bowl
Fig. 10a Fig. 10b
BL700_30_SERIES_IB_ENG_120427_2.indd 12 12-04-30 8:41 AM
To Next Page
Loading...
Need help?
General
