TIP: If the Stacked Blade
Assembly is not fully
seated, you will not be
able to install and lock the
lid into position.
TIP: To learn more about
the unit’s programs, refer
to page 9.
NOTE: DO NOT add
ingredients before
completing installation
of the Stacked Blade
Assembly.
NOTE: The pitcher can
be installed in two different
orientations. The handle
can be positioned on the
front-right corner of the
motor base or the front-left
corner of the motor base.
USING YOUR TOTAL CRUSHING® PITCHER
IMPORTANT: Review all
warnings on pages 3–6
before proceeding.
1 Plug in motor base and
place on a clean, dry,
level surface such as a
countertop or table.
2 Lower the pitcher onto the
motor base. The handle
should be aligned slightly
to the right and the pitcher
should be oriented so the
LOCK symbols on the
motor base are visible.
To Next Page
Loading...
Need help?
General