27 28AUS 1800 099 385 or NZ 0800 112 660 ninjakitchen.com.au
ENGLISH
USING YOUR
AUTO-SPIRALIZER
IMPORTANT: Review all
warnings on pages 3–6
before proceeding.
IMPORTANT: After
spiralizing an ingredient,
all leftover pieces must
be removed from the
Collecting Bowl and
Blade Disc before
spiralizing again.
NOTE: To find out how
to properly prep your
ingredient, refer to the
Food Prep section in your
Quick Start Guide or your
Inspiration Guide.
NOTE: Never spiralize
multiple ingredients at
one time.
1 Before spiralizing, prepare
your ingredient by cutting
it so it is no more than
3 inches wide. Place the
prepped ingredient into the
Feed Chute, through the
opening at the top.
2 Center the ingredient
on the pin in the center
of the Blade Disc, then
push down, securing the
ingredient onto the pin.
3 Place the Food Pusher on
top of the ingredient and
press down firmly to hold
in place.
4 Select GO to begin
spiralizing. Continue to
press firmly with Food
Pusher to guide ingredient
through Feed Chute.
5 Spiralizing is complete
when the Food Pusher sits
flat atop the Feed Chute
Lid. Press STOP to power
off the motor.
To Next Page
Loading...
Need help?
General