BACK BURNER
MID BURNER
FRONT BURNER
The pilot burner is the small vertical burner
located on the right-hand side of the grill. The
pilot burner needs to be lit for the main burners
to ignite.
During the ignition process, the pilot burner will
be the only burner that ignites before selecting
a function.
BE SURE TO FOLLOW THESE STEPS
BEFORE IGNITING BURNERS:
BEFORE YOUR FIRST COOK:
RUN A BURN-OFF CYCLE
GET TO KNOW YOUR BURNERS:
Pilot Burner
SCAN HERE
for step-
by-step
ignition
video
Plug In Grill: Plug in using a 3-prong grounded
extension cord, rated for outdoor use.
DOT 4BA24
02 21
Open Grill Lid before igniting.
Turn On Gas Supply by opening tank valve
completely.
After the pilot burner is lit, turn the dial to select
a function and ignite the main burners.
The 3 main horizontal burners automatically
adjust depending on your function and
temperature selection.
Main Burners
BACK BURNER
MID BURNER
FRONT BURNER
8
ninjakitchen.com
7
ninjakitchen.com
HOW TO IGNITE BURNERS AND SET TEMPERATURE
STEP 1: IGNITE PILOT BURNER
UP TO 10
SECONDS
Push in Burner dial and turn to IGNITE PILOT.
Hold in for up to 10 seconds.
You will hear a ticking noise, indicating the pilot
burner is igniting.
NOTE: Pilot burner flames are small and may
be dicult to see in direct sunlight. Flames
will become more visible when the main
burners are lit.
STEP 2: TURN ON MAIN BURNERS
& SET TEMPERATURE
RELEASE
& TURN TO
FUNCTION
Follow ignition instructions, set grill temperature
to 600°F and leave on for at least 20 minutes
before cooking on your grill for the first time.
Set a Temperature:
Turn the TEMPERATURE CONTROL dial to set
a precise temperature within the temperature
range of your selected function.
Switch functions to access dierent
temperature ranges.
The display screen will flash between the set
temperature and current temperature during
preheat and will show the set temperature when
the grill is preheated.
TIP: Reference cooking charts in the charts
section for chef-recommended temperatures
and cook times for dierent food loads for
each cooking function.
Turn on the Main Burners:
Release dial and turn counterclockwise to select
a cooking function to turn on the main burners.
Main burners will automatically adjust based
on the function/temperature selected, and the
active burners will illuminate on the LED screen.
Look through the peep hole to see if the pilot
burner is ignited.
If ignition was unsuccessful, turn dial to OFF
and try again.
Ensure dial is set directly on a function and lined
up with its respective tick mark.
To Next Page
Loading...
