10 Place the unplugged motor base
on a clean, dry, level surface such
as a countertop or table. Press
downward on the motor base to
adhere the suction cups to the
work surface. Plug the motor
base into a wall outlet.
11
Turn the Single-Serve Cup upside
down and install on the motor base.
Align the tabs on the cup with the
slots on the base, then twist until it
clicks into place. Touch the Power
symbol to turn unit on. The available
program buttons will illuminate and
the unit will be ready for use.
NOTE: Pre-set programs have pauses
and changes in speed throughout
the cycle.
NOTE: The Smart Screen™ Motor
Base can detect which container is
on the motor base. Only the functions
available for a particular container will
illuminate on the touchscreen.
12 If using a pre-set program, first
select the program that best suits
your recipe. The pre-set feature will
automatically stop the unit at the end
of the program. To pause the unit at
any time, touch the currently active
program a second time. Reference
page 11 for program descriptions.
15
Turn cup over so blade assembly
is on top. Rotate blade assembly
counterclockwise to remove. To take
your blended contents on the go,
place the spout lid on cup and turn
clockwise to seal.
16
Unplug the unit when finished. To lift
the motor base, place your hands
underneath both sides of it and gently
pull the unit up and toward you. Refer
to the Care & Maintenance section for
storing instructions.
TIPS:
• To learn more about the programs
that work with your Single-Serve
Cup, refer to page 11.
13 When blending is complete, rotate
cup counterclockwise to remove
from motor base and place cup on
a level surface. Pressure must be
released before opening the cup.
14
Open the Flip & Seal Lid by
pressing the tab and lifting. To
release the vacuum seal, gently lift
the FreshVac Tab. Air will enter the
cup, making it easy to remove the
blade assembly.
To Next Page
Loading...
Need help?
General