EN-4
4. Getting Started
Initial Setup
Please follow the initial setup procedure before using the device for
the rst time or after you have replaced the battery. When the battery
power is extremely low and “ & ” appears on the screen, the
meter cannot be turned on.
Step 1: Enter the Setting Mode
1. The meter turns on automatically once a new battery is inserted.
2. Start with the meter o (no test strip inserted). Press and hold and at the same
time for ve seconds.
Step 2: Conguring the Settings (Date, Time, and Reminder Alarm)
Press or to adjust the value or enable/disable the setting. Then press MAIN
button to conrm the setting and switch to another eld.
Set [Year] Set [Month] Set [Day] Set [Hour]
Set [Minute] Set [Beep On,
Beep O ]
Set [Reminder
Alarm]
Set [Alarm Time
(Hour)]
Set [Alarm Time
(Minute)]
To Next Page
Loading...
