Nipro 4Sure Smart Duo - Blood Glucose Testing; Lancing Device and Blood Sample

EN-6
Preparing the Lancing Device
1. Remove the cap.
2. Insert a new lancet rmly into the white lancet holder cup.
3. Remove the protective disk on the lancet.
Hold the lancet rmly in place and twist o the protective disk.
4. Replace the cap until it snaps or clicks into place.
5. Rotate the dial to set the desired lancing depth.
6. Pull the cocking control out until the orange bar appears on the release button
window.
Important!
To reduce the chance of infection:
• Never share a lancet or a lancing device.
• Always use a new, sterile lancet. Lancets are for single use only.
• Avoid getting hand lotion, oils, dirt, or debris in or on the lancets and the lancing
device.
Obtaining the Blood Sample
Please follow the suggestions below before obtaining a drop of blood:
• Wash and dry your hands before starting.
• Select the puncture site either on your ngertips or other body parts.
• Rub the puncture site for about 20 seconds before penetration.